Theatre of Magic Motorized TigerSaw and Lighted Mirror Marquee NOW With LED’s!
Enhance your Theatre of Magic with a Motorized GOLD mirror Tiger Saw Blade and Lighted GOLD mirror Marquee accessory for the Theatre of Magic pinball machine.
The GOLD mirror Tiger Saw blade is the exact size of the original gray saw blade. The GOLD mirror surface really stands out in the game and shimmers when it runs. The blade comes mounted and balanced on the motor assembly and control circuit. It’s ready to go when you receive it. The motor for the saw blade is a direct drive system that has no belts or rubber tires to slip and fail. The motor/blade assembly slips right on to the Tiger Saw bracket with no drilling or permanent modifications. The motorized Tigersaw works with ALL ROM versions. If it is used with ROM 1.3X and below, the saw will run each time the tiger captive balls are hit. If ROM 1.4H is installed, the saw will also run during tiger mode play. Version 1.4H ROMs are available from sources on the web. A new version security PIC chip EWE22 for U22 is needed to go with ROM 1.4H and is available from www.shiftedbits.com.
The lights on the GOLD mirror Marquee change function with different orientations of the Trunk in a way that really enhances the game play. When the trunk is open the lights will CHASE (flash in sequence). When the target is forward all the lights will FLASH on and off. When the green bulb is forward the all the lights will DIM and BRIGHTEN. The lights are normally off when the trunk is closed, but can be activated by certain ramp shots. A center loop shot will cause a short clockwise CHASE sequence. A center staircase shot will cause a short FLASH sequence. A right staircase shot will cause a short counterclockwise CHASE sequence. The Marquee is compatible with ALL ROM versions
The Theatre of Magic Motorized TigerSaw and Lighted Mirror Marquee kit, shown below, comes with the motorized Tigersaw blade assembly, the lighted mirror assembly, the controller card and mounting hardware. (Note the mirror in the picture has plastic protective film on it and looks dull.) Installation takes just a few minutes with a screwdriver. After mounting, the Tigersaw assembly and the Lighted Marquee assembly plug onto the controller card. The controller board plugs on to the CPU board and connects to the Power Driver board in the backbox. There are no tricky switches to set up and no circuit boards to solder under your playfield.
Click HERE for installation instructions.